-
Unplug the power cord for your
Cable/DSL modem.
-
Unplug the power cord for your
router.
-
Disconnect the Ethernet cable
connecting your Cable/DSL modem to your router from the WAN/Internet
port on your router, and connect that end of the Ethernet cable
to the WAN port on the Phone Adaptor.
-
Connect one end of the Ethernet
cable we provide into the PC port on the Phone Adaptor. Connect
the other end of this Ethernet cable into the WAN/ Internet port
on your router.
-
Plug the power cord back into
your Cable/DSL modem and wait about two minutes for it to start
up before continuing.
-
Plug the power cord back into
your router and wait about two minutes for it to start up before
continuing.
-
Connect a telephone to the LINE
1 port of the Phone Adaptor using a standard phone line.
-
Plug the power cord into the
POWER port on the Phone Adaptor and into an electrical outlet. This
turns your Phone Adaptor on. You do not need to unplug it when not
in use.
-
Check that the POWER light
on the Phone Adaptor is lit. Wait at least five minutes for the
Phone Adaptor to start up. There may be updates that need to
be downloaded such as new firmware or changes to your features.
Do not interrupt the registration process by unplugging the power
or lifting the receiver on your phone during the startup process.
Interruption of the startup may result in interruption of service.
-
Pick up your telephone receiver
and listen for a dial tone. If you hear a dial tone, you have
finished the installation and can begin making calls. You will need
to use 11-digit dialing (i.e. 1-Area Code-555-1234). If you
do not get a dial tone, please refer to the Advanced Installation
and Troubleshooting section of the Installation Guide.
